Vinyl Tutorial

You’re on this page because you’re looking to apply one of our vinyl designs. This tutorial will take you step-by-step through the process, with helpful gifs, links, and tips.

Compatible fabrics:

Please note that finishes on fabrics are sometimes not listed and can affect the quality of the application, or the time it takes to adhere.

  • Cotton / Denim
  • Polyester
  • Cotton/polyester blend

What you need:

  • Vinyl (included)
  • Parchment paper (included)
  • Weeding tool (included)
  • Iron
  • Ironing board
  • Compatible fabric

1. Peel back excess vinyl

WE'RE GOING TO PEEL UP THE VINYL WE DON'T WANT IN THE DESIGN.
USE THE WEEDING TOOL TO PEEL UP MORE DIFFICULT SECTIONS, LIKE THE MIDDLE OF LETTERS.
THIS IS WHERE YOU CAN GET CREATIVE, BY DECIDING WHAT YOU PEEL UP.

2. LAY DOWN ON FABRIC

LAY THE DESIGN DOWN ON THE FABRIC WITH THE STICKY SIDE DOWN. MAKE SURE IT'S A COMPATIBLE FABRIC. MAKE SURE IT'S FLAT WITHOUT WRINKLES OR BUMPS.
PLACE PARCHMENT PAPER OVER THE WHOLE DESIGN.

3. IRON

PLACE EVERYTHING ON AN IRONING BOARD, OR SOMETHING HEAT RESISTANT LIKE A COOKIE SHEET. SET IT TO THE HOTTEST SETTING. PRESS DOWN FIRMLY.

4. PEEL UP TRANSPARENCY

THE TRANSPARENCY PAGE SHOULD NOW PEEL UP LIKE BUTTER. IF ANY OF THE VINYL STARTS TO LIFT UP, REPEAT THE IRONING PROCESS UNTIL IT DOESN'T.
AND THERE'S YOUR DESIGN!

Care Instructions

Our designs are fully machine-washable. They are best-kept pristine by following a few simple guidelines. Wait 24 hours before washing. / Wash inside out. / Hang dry. / Do not bleach or iron over design.

Any trouble?

[email protected]

0

Start typing and press Enter to search